Tecfrigo Sommelier 63 Manual De Instrucciones página 7

The handle installing (FIG.1)
The wine cooler comes with one metal stainless steel handle. To install simply screw them to the door
with the supplied screws.
Wine shelves (FIG.2)
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out. Any of the wine
shelves can be removed to accommodate larger bottles. Maintain a minimum 20mm between bottle and
back plate.
To remove a shelf
Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out.
Operating elements and displays (FIG.4)
The device transmits the following signal sounds as an acoustic feedback signal:
Please note
► Use the buttons and to set the temperature for the two top shelves in the range of 3-22°C.
► Temperature recommendations: Red wine: 12°C – 16°C and white wine 6°C – 10°C.
► The display indicates the average temperature of the appliance at the moment.
► When working both up and down zone, setting temperature of upper zone must lower than down zone.
If you press the power button of :
• Upper zone -> both zones are switched on
• Down zone -> only down zone starts working
You can set the temperature as your desire by pressing the button. There are three press-button on the
panel and to adjust the temperature by 1°C among 3-22°C. You can tune the interior light on or off by
pressing the "Light" button. Pushing the temperature key up and down for 5 seconds, then, temperature
display mode will be exchange between °C and °F.
Door gasket
• Be sure to keep the door gasket clean to keep the unit running efficiently.
Vent opening
• Dust or anything else may block the vent and hinder the cooling efficiency of the appliance. Vacuum the
vent if necessary.
ON/OFF of the up zone system
ON/OFF (LED light)
UP (TEMPERATURE)
DOWN (TEMPERATURE)
Operator's guide
7
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO