General Safety Instructions - LaserLiner CombiCross-Laser 5 DLD Manual De Instrucciones

Read the operating instructions and the enclosed brochure „Guarantee
!
and additional notices" completely. Follow the instructions they
contain. Safely keep these documents for future reference.
Function / Application
Cross-line laser vertical and horizontal alignment
– Extremely bright, green laser cross at front and 3 vertical red laser lines
– The slope-mode feature is an extra that permits gradients to be laid out.
– The pivoted housing can be turned with a vernier adjustment mechanism
to permit exact positioning of laser lines.
– Connectible laser lines
– Automatic levelling range 2°, accuracy 2 mm / 10 m
– A simple, precise plumb function is afforded by the additional plumb laser
at the bottom and the laser cross at the top.
– The vertical lines are aligned at right angles to one another.

General safety instructions

Caution: Do not look directly into the beam. Lasers must be kept out of
reach of children. Never intentionally aim the device at people. This is a
quality laser measuring device and is 100% factory adjusted within the
stated tolerance. For reasons of product liability, we must also draw your
attention to the following: Regularly check the calibration before use, after
transport and after extended periods of storage. We also wish to point out
that absolute calibration is only possible in a specialist workshop. Calibration
by yourself is only approximate and the accuracy of the calibration will
depend on the care with which you proceed.
10
GB
Laser radiation!
Do not stare into the beam
or observe it directly with
optical instruments.
Class 2M laser
< 5 mW · 510-670 nm
EN 60825-1:2007-10