Replacing The Ribbon; Error Messages - Amano TCX-22 Operación Manual

Replacing the Ribbon

To Remove:
1. Remove the cover.
2. Pull the two white release
tabs upward and remove the
ribbon cassette.
To Insert:
1. If the print mechanism is down and a piece of paper cannot be
inserted, press the RESET button to move the carriage up. This will
make the ribbon installation easier.
2. Insert the ribbon cassette. Be sure to mount the ribbon between
the printer head and ribbon guide as arrows illustrate.
3. Turn the knob on the cassette clockwise one turn to take up any
slack in the ribbon.
4. Replace the cover and check the print quality to confirm that you
have installed the ribbon correctly.

Error Messages

Error Code
E1 Pr
E2 Pr
E3 Pr
E4 Pr
Er
dL
For error messages E1 through E4, turn off the power before checking to
see that the carriage is not stuck or jammed. Also, check to see that the
ribbon cables are in good condition. After clearing any jams, restore the
power and press the RESET button. Contact your Amano Cincinnati
representative for assistance.
The dL error message signifies that an attempt was made to get into the
Program mode during the Daylight Saving changeover one-hour lockout.
Wait one hour and you will be able to program the clock.
TCX-22
Cause
Home sensor, motor carriage stuck
Time sensor, carriage stuck
Home sensor
Carriage stuck
General print error
Daylight Saving Time Program
Page 16
Amano Cincinnati, Inc.