Power Options; Connecting The Ac Adapter - Amano TCX-22 Operación Manual

Power Options

The TCX-22 can be powered by either an AC Adapter or a 12 volt
Sealed Rechargeable battery. The Battery Power Switch on the base
enables you to turn the Battery Power ON or OFF. The battery is
equipped to maintain normal operations for 1 week and/or 5000 prints in
the event of an A/C power failure.
Installing the 12 Volt Battery
1.
Remove the AC Adapter if equipped
and remove the cover.
2. Lay the unit down clock face up
3. Remove left battery bracket screws
4.
Pull out the left battery bracket.
5.
Carefully insert the battery with the
positive and negative clips facing
outwards and to the right.
6.
Install the left battery bracket
7.
Observing polarity, attach the "Red"
Positive female wire harness to the
"Red" (+) Positive male connector on the Battery.
8. Attach the "Black" Negative female harness wire to the "Black" (-)
Negative connector located on the battery.
9. Set the Battery Power to the "Connected" position.
Note: Recharge the battery at least every two weeks or every 5000
prints. The minimum charging time should be 12 hours and the switch
should be turned off when the unit is not in use.

Connecting the AC Adapter

1. Set the Battery Power Switch to the OFF position.
2. Verify that the AC outlet voltage falls in the range of 100-240 Volts
AC. Verify that the cord and plug are appropriate for your AC source.
3. Plug the connector end of the AC Adapter into the Power Connector
and the other end into a properly grounded 120 or 240 Volt outlet.
TCX-22
Page 3
Amano Cincinnati, Inc.