Downloading Further Instructions - Balluff BML-SB/C/E0-Q-M4-0-KA Serie Instrucciones Breves

BML-S _ B/C/E0-Q _ _ _ -M4_ _ - _ 0-KA _ _ /KA _ _-S284
Incremental Magnetic Linear Encoder
EU Directive 2004/108/EG (EMC Directive) and EMC law
Noise immunity: EN 61000-6-1/EN 61000-6-2
Emission: EN 61000-6-3/EN 61000-6-4
Intended use
The BML magnetic linear encoder is intended for
communication with a machine control (e.g. PLC). It is
intended to be installed into a machine or system. Flawless
function in accordance with the specifications in the
technical data is ensured only when using original
BALLUFF accessories. Use of any other components will
void the warranty. Non-approved use is not permitted and
will result in the loss of warranty and liability claims against
the manufacturer.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com/downloads-bml or
requested via e-mail from service@balluff.de.
Installation and connection
Linear and rotative applications:
Roll
Y
5
5
Forwards direction of travel, A before B
Free area of magnetizable material
Connection type: ...-KA_ _-S284
~49
Pay attention to correct
orientation!
The sensor head must be installed
with its left side over the incremental
track (only ...-M41_-...).
www.balluff.com
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the linear encoder will
not result in hazards to persons or equipment.
If defects and unresolvable faults occur in the linear
encoder, take it out of service and secure against
unauthorized use.
+Yaw
X
+Pitch
10
Z
Connection type: ...-KA_ _
Start of magnetic tape
General safety notes
Distances/angles
Z 0.01 to 2 mm
(sensor/magnetic tape (with cover strip max. 1.85 mm)
gap [mm])
Y No or pole-periodic signal:
(side offset) Max. ±1 (magnetic tape width 10 mm)
Max. ±0.5 (magnetic tape width
<10 mm)
Single, double, or fixed-periodic
signal:
Max. ±0.5 mm
X Only rotative applications:
(tangential offset) Max. ±0.5 mm
Yaw < ±3°
(yaw/alignment error)
Pitch < ±1°
(pitch/longitudinal
slope)
Roll
< ±3°
(lateral slope)
2.5
17 4
Ø3.5
Ø6
35
Active measuring surface
BML-M...-I4_-... magnetic tape
(not included in the scope of delivery)
Left
Rear Front
Right
Reference point
File no.
E227256
10
End of magnetic tape
english 1