Find The Best Stimulation Level For Your Pet; Teaching Basic Obedience; The "Sit" Command - Petsafe HDT11-13910 Instrucciones De Uso

Find the Best Stimulation Level for Your Pet

Important: Always start at the lowest level and work your way up.
The Remote Trainer has 8 different Stimulation Levels. This allows you to choose the stimulation
that is best for your pet.
Once you have placed the Receiver Collar on your pet, it is time to find the Stimulation Level
that is best for him. This is called the Recognition Level.
A slight change in your pet's behavior, such as looking around in curiosity, scratching at his
collar, or flicking his ears, indicates the Recognition Level that is best for him.
Follow the steps below to find your pet's Recognition Level:
1. Starting at Level 1 on the Intensity Dial, press the Stimulation Button continuously for 1 to 2 seconds.
2. If your pet shows no reaction, repeat this stimulation level several times before moving up to
the next level.
3. YOUR PET SHOULD NOT VOCALIZE OR PANIC WHEN RECEIVING STIMULATION. IF THIS
HAPPENS, THE STIMULATION LEVEL IS TOO HIGH AND YOU NEED TO GO BACK TO THE
PREVIOUS LEVEL AND REPEAT THE PROCESS.
4. Move up through the stimulation levels until your pet reliably responds to the stimulation.
5. If your pet continues to show no response at Level 8, check the fit of the Receiver Collar. If
your pet has long or thick hair, replace the Contact Points with the longer set. Then go back
to #1 and repeat the process. If this still does not yield any results, your pet's hair may need
to be trimmed around the Contact Points.
If all of these steps have been done and your pet continues to show no reaction to the
stimulation, see the "Test Light Instructions" section.
If after completing all of these steps your dog still does not indicate he is feeling the stimulation,
please contact Customer Care Center or visit our website at www.petsafe.net.

Teaching Basic Obedience

The "Sit" Command

1. Put a separate, non-metallic collar on your pet's neck ABOVE
the Receiver Collar, and attach a long leash. Note: Be sure the
extra collar does not put pressure on the Contact Points.
2. Hold your leash and Handheld Remote in one hand. Press
and hold the Tone B Button while saying "Sit" and if necessary
using your free hand to guide your pet into a "Sit" position.
Release the Tone B Button immediately when your pet sits.
Repeat this several times.
3. If your pet sits reliably on receiving the Tone B and the spoken
"Sit" command, then training is complete. Release your pet
from the "Sit" position and praise him. If not, move on to Step 4
12 Customer Care Center 1-800-732-2677