Troubleshooting
Problem
Cause
The motor does not
• There is no spark.
start.
• There is no fuel.
• The motor is choked.
• The starter jack is
pulling with more
difficulty than when
new.
The motor starts but it
• The motor needs a
is not accelerating.
few minutes to warm
up.
The motor stats but it
• Carburetor needs
only runs high speed
adjustment.
with half choke.
• Check the oil / fuel
The motor is not
mix.
gaining full speed and
• The air filter is dirty.
has too much smoke
• The anti spark guard
emissions.
screen is dirty.
Solution
• Check the spark. Remove the motor cover. Remove the spark plug from
the cylinder. Connect the spark plug cable and set it on top of the motor
cylinder with its metal part touching the cylinder. Pull the starter and watch
the spark in the spark plug electrode. If there is no spark, repeat the test
with a new spark plug.
• Press the starter choke until the fuel is visible in the choke. If no fuel is
showing it means that the fuel supply primary system is blocked. Contact
an Authorized Service Center. If the starter choke fills with fuel, it means
the motor is choked.
• With the switch off, remove the spark plug. Move the choke lever in to
the "
" posotion and pull the starter handle 15 to 20 times to eliminate
the fuel excess in the motor. Clean the spark plug and reinstall. Follow
the normal starting procedure (consult page 8). If the motor does not
start, move the choke lever in to the "
procedure. If the motor is still not running, repeat the procedure but this
time using a new spark plug.
• Take the tool to a
• Allow the motor to warm up completely. If the motor is not accelerating
after three minutes contact your
Center.
• Take the tool to a
• Use new fuel and the right oil mix for two-cycle.
• Clean the air filter. See page 10.
• Take the tool to a
" position and repeat the starting
Authorized Service Center.
Authorized Service
Authorized Service Center.
Authorized Service Center.
ENGLISH
11