Installing Or Removing Battery Pack; Safety Instructions For Charger And Batteries - Lincoln B Serie Manual De Instrucciones

Model 1200, 1240, 1242, 1242E, 1244, 1244E
PowerLuber Grease Gun

INSTALLING OR REMOVING BATTERY PACK

TO REMOVE BATTERY PACK:
tery release buttons (one button on each side of battery pack)
and pull battery pack out of PowerLuber.

SAFETY INSTRUCTIONS FOR CHARGER AND BATTERIES

This manual contains important safety and operating instruc-
tion for Lincoln Model 1210 or 1210E Battery
Charger.
1. Before using a battery charger, read all instructions and
cautionary markings on Battery Charger, Battery Pack, and
product using battery.
2. CAUTION: To reduce the risk of injury, Lincoln Model 1210
or 1210E Chargers should only be used to charge Lincoln
battery pack Model 1201. Other types of batteries may
burst causing personal injury and damage. Do not charge
Lincoln Model 1201 Battery Packs with any other charger.
3. Do not expose charger to rain, snow or frost.
4. Do not abuse cord. Never carry charger by cord or yank it
to disconnect from receptacle. Pull by plug rather than cord
when disconnecting charger. Have damaged or worn power
cord and strain reliever replaced
immediately. DO NOT ATTEMPT TO REPAIR POWER
CORD.
5. Make sure cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
6. Do not use an extension cord unless absolutely necessary.
Use of improper extension cord could result in a risk of
fire and electric shock. If an extension cord must be used,
make sure:
A That the extension cord is properly wired and in good elec-
trical condition.
B Wire Size of cord is at least as specified in following chart:
LENGTH OF CORD IN FEET (M) 25 (7.5) 50 (15) 100 (30) 150 (45)
AWG SIZE OF CORD (mm²)
C If an extension cord is to be used outdoors it must be
marked with the suffix W-A following the cord type
designations. For example -SJTW-A to indicate it is accept-
able for outdoor use.
7. Do not operate charger with damaged cord or plug. Have
them replaced immediately, to avoid a hazard DO NOT AT-
TEMPT TO REPAIR POWER CORD.
8. Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way, take it to
a qualified serviceman.
9. Do not disassemble charger or battery pack. Take it to a
qualified serviceman when service or repair is required.
Incorrect reassembly may result in risk of electrical shock
or fire.
10. Unplug charger from outlet before attempting any mainte-
nance or cleaning to reduce risk of electric shock.
11. Charge the battery pack in a well ventilated place, do
not cover the charger and battery with a cloth, etc., while
charging.
Form 402022
Depress the two bat-
SAVE THESE INSTRUCTIONS
18 (1) 18 (1) 18 (1) 16 (1.5)
TO INSTALL BATTERY PACK:
with opening in PowerLuber handle and push battery pack into
handle until it locks in place.
12. Do not store the charger or battery packs in locations
(such as a metal tool shed, or a car in the summer) where
the temperature may reach or exceed 122° F
(50° C) , which can lead to deterioration of the storage
battery.
13. Do not charge battery pack when the temperature is BE-
LOW 32° F (0° C)or ABOVE 104° F (40° C). This is very
important for proper operation.
14. Do not incinerate battery pack It can explode in a fire.
15. Do not charge battery in damp or wet locations.
16. Do not attempt to charge any other cordless tool or battery
pack with the Lincoln Model 1210 or 1210E charger.
17. Do not short across the terminals of the battery pack.
EXTREMELY HIGH TEMPERATURES COULD CAUSE
PERSONAL INJURY OR FIRE.
18. Dispose of expended batteries properly. The Lincoln
Model 1201 Battery Pack contains rechargeable, nickel-
cadmium batteries. These batteries must be recycled or
disposed of properly. Drop off expended battery packs at
your local replacement battery retailer, or your recycling
center.
Users in the United States NOTE:
Applicable fees for the collection and recycling of these
batteries have been paid to the RBRCTM. For further
information, call 1-800-8BATTERY.
1210 or 1210E
Battery Charger
Figure 2
Align battery pack
1201
Battery
Page Number - 5