Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
9.
When starting engine, position yourself as recommended
in Figure I0 and start engine according to instructions
given in engine operator's manual.Also see operating
instructions tag located on the pressure washer.
WARNING
ALWAYS point gun in safe direction
and squeeze
spray gun
trigger, to release
pressure
and avoid kickback
each time,
before
starting
engine.
When
starting
engine,
pull cord slowly until resistance
is felt
and then
pull rapidly to avoid kickback.
After each starting
attempt,
where
engine fails to run, always
point gun in safe direction
and squeeze
spray gun trigger
to
release
high pressure.
Firmly grasp spray gun with both
hands when
using high
pressure
spray to avoid injury when gun kicks back.
NOTE:
Always keep the throttle
lever in the "Fast"
position when operating
the pressure washer.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
Keep at least S ft. (IS2 cm) clearance on all sides of pressure
washer
including overhead.
Code of Federal Regulation
(CFR) Title 36 Parks, Forests, and
Public Property
require equipment
powered by an internal
combustion
engine to have a spark attester, maintained
in
effective working
order, complying
to USDA Forest service
standard
5 I00- IC or later
revision,
in the State of California
a
spark attester
is required
under
section
4442 of the California
Public resources
code. Other
states
may have similar
laws.
How
to StopYour
Pressure
Washer
I.
Let engine
idle for two
minutes,
2.
Turn
engine
off according
to instructions
given in
engine
operator's
manual.
3.
ALWAYS
point
gun in a safe direction
and squeeze
spray gun trigger
to release
retained
high water
pressure.
IMPORTANT:
Spray gun traps
high water
pressure,
even
when
engine
is stopped
and water
is disconnected.
WARNING
Keep high pressure hose connected
to pump and spray gun
while system is pressurized.
ALWAYS point gun in safe direction
and squeeze spray gun
trigge_; to release high pressure, every time you stop engine.
Engage trigger lock when not in use.
4.
Engage trigger
loci< on spray gun when
not in use.
O
Publicidad
