Descargar Imprimir esta página

Pump Maintenance - Troy-Bilt 020287 Manual Del Operario

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 5: Maintenance
Pump
Maintenance
Changing
Pump Oil
Change oil after first 50 hours of operation
and then every
200 hours or 3 months, whichever
occurs first.
NOTE:When
changing pump oil, use only high quality
nondetergent
30 weight oil. Use no spedal additives.
Change
pump oil as follows:
[.
Clean area around brass oil drain plug at bottom
of
pump.
2.
Remove oil drain plug. Drain oil completely
into an
approved container.
3.
When oil has completely
drained, install oil drain plug
and tighten firm[),.
4.
Clean area around pump oil dipstick. Remove dipstick
and fill pump with recommended
oil to "Full"
marl< on
dipstick (typically 0.43L or 15 oz.).
5.
Install pump oil dipstick.
6.
Wipe up any spilled oil
D ata Tag
Data tag information
is very important ff you need help from
our Customer Service Department or an authorized service
dealer.
• The data tag (Figure 16) is located on the base of the
pressure washer. For future reference, please copy the
mode[, revision, and serial number of the pressure washer
in the space below.
MODEL
[
]4_
REV N O[
1_
SER,AL [
1_
Ps,
[
i
GPM [
i
O TRO_RM-T'_
_,_
Copy Model
Number
Here
_Copy
Revision
Here
Copy Serial
Number
Here
O

Publicidad

loading