Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
Attach
Handle
I.
Place handle assembly onto handle supports connected
to main unit. Hake sure holes in handle align with holes
on handle supports (Figure 2).
Handle
1 I
Supports
1 I
NOTE:
Itmay be necessaryto move the handlesupports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts through holes from outside of unit
and attach plastic knob on inside of handles (Figure 3).
Tighten by hand.
3.
Insert multi-colored
spray tips in spaces provided in
handle.
Add
Engine
Oil
and
Fuel
• Place pressure washer on a level surface.
CAUTION
• Refer to engine operator's
manual for oil and fuel fill
information.
• Damage to equipment
resulung from failure to follow
this
instruction
will void warranty.
• Refer to engine operator's
manual and follow oil and fuel
recommendations
and instructions.
NOTE:
Check oil often during engine break-in. Refer to
engine operator's
manual for recommendations.
Connect
Hose
and Water
Supply
to
Pump
IMPORTANT:To
avoid pump damage,you
must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
I.
Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 4). Pull down
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of tight connection.
\
Connect high
pressure hose
here.
\
NOTE:
Remove and discard
all pump shipping
caps before
attaching
hoses.
O
Publicidad
