Descargar Imprimir esta página

Troy-Bilt 020287 Manual Del Operario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 1: Safety Rules
WARNING
ALWAYS point gun in safe direction
and squeeze
spray gun
trigger, to release
pressure
and avoid kickback
each time,
before
starting
engine.
Engage trigger
lock when
not in use.
When
starting
engine,
pull cord slowly
until resistance
is felt
and then pull rapidly to avoid kickback.
After each starting
attempt,
where
engine fails to run, always
point gun in safe direction
and squeeze
spray gun trigger to
release
high pressure.
Firmly grasp spray gun with both
hands when
using high
pressure
spray to avoid injury when gun kicks back.
WARNING
DO NOT
touch
hot surfaces
and avoid hot exhaust
gases.
Allow equipment
to cool before
touching.
Keep at least S ft. (I 52 cm) clearance
on all sides of pressure
washer
including
overhead.
Code
of Federal
Regulation
(CFR) Title 36 Parks, Forests,
and
Public Property
require
equipment
powered
by an internal
combustion
engine to have a spark arrested;
maintained
in
effective
working
order,
complying
to USDA Forest
service
standard
SI00-IC
or later revision.
In the State of California
a
spark arrester
is required
under section
4442 of the California
Public resources
code. Other
states
may have similar laws.
WARNING
, DO NOT
wear
loose clothing, jewelry
or anything
that may
be caught in the starter
or other
rotating
parts.
• Tie up long hair and remove
jewelry.
WARNING
NEVER aim spray gun at people, animals or plants.
DO NOT allow CHILDREN
to operate
pressure washei:
NEVER repair high pressure hose. Replace it.
NEVER repair leaking connections
with sealant of any kind.
Replace o-ring or seal.
Keep high pressure hose connected
to pump and spray gun
while system is pressurized.
ALWAYS point gun in safe direction
and squeeze spray gun
trigge_, to release
high pressure,
every time you stop engine.
Engage trigger
lock when
not in use.
WARNING
Always wear safety goggles when using this equipment
or in
vicinity
of where equipment
is in use.
Before starting the pressure washe_, be sure you are wearing
adequate safety goggles.
WARNING
WHEN
ADJUSTING
OR MAKING
REPAIRSTOYOUR
PRESSURE
WASHER
• Disconnect
spark plug wire fi'om spark plug and place wire
where
it cannot
contact
spark
plug.
WHEN
TESTING
FOR
ENGINE
SPARK
Use approved
spark plug teste_:
DO NOT
check for spark with spark plug removed.
O

Publicidad

loading