Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
6.
Apply
detergent
to a dry surface,
stardng
at lower
portion
of area to be washed
and work
upward,
using
long, even, overlapping
strokes.
DO
NOT
allow
detergent
to dry on (prevents
streaking).
7.
Allow
detergent
to soak in between
3-5
minutes
before
washing
and rinsing.
Reapply
as needed
to
prevent
surface
from
drying.
IMPORTANT:You
must flush
the injection
system
after
each use by placing
the filter
into
a bucket
of clean water,
then
run the pressure
washer
in low
pressure
for
I-2 minutes.
Pressure
Washer
Rinsing
After
you
have
applied
detergent,
scour
the
surface
and
rinse
it clean
as follows:
I.
Engage trigger
lock on spray gun.
2.
Remove
black
detergent
spray tip from
nozzle
extension.
3.
Select
and install
desired
high pressure
spray tip
following
instructions
in "How
to Use SprayTips'.
4.
Keep
spray gun a safe distance
from
the area you plan
to spray.
WARNING
Keep spray nozzle between
8 to 24 inches away fi'om cleaning
Surface.
Operate
this unit on a stable surface.
Be extremely
careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicks back.
Increase (decrease) spray pressure by turning pressure
control knob clockwise (counterclockwise) (Figure 12).
Use lower pressure to wash items such as a car or
boat. Use higher pressure to strip paint and degrease
driveways.
6.
Apply high pressure spray to small area and check
surface for damage. If no damage is found, you can
assume it is okay to continue cleaning.
7.
Start at top of area to be rinsed, working
down with
same overlapping strokes as you used for cleaning.
Cleaning
Detergent
Siphoning
Tube
If you used the detergent
siphoning
tube,you
must
flush it
with
clean water
before
stopping
the engine.
I.
Place detergent
siphon
tube/filter
in a bucket
full of
clean water.
2.
Engage trigger
lock
on spray gun.
3.
Attach
black cleaning
detergent
nozzle.
4.
Flush
for
I-2 minutes.
5.
Shut off engine.
6.
ALWAYS
point
gun in a safe direction
and squeeze
spray gun trigger
to release
retained
high water
pressure.
IMPORTANT:
Spray gun traps
high water
pressure,
even
when
engine
is stopped
and water
is disconnected.
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine
on your
pressure
washer
for
3-5 minutes
without
pressing
the trigger
on the spray gun,
circulating
water
in the pump
can reach
temperatures
above
125°F.The
system
engages to cool the pump
by
discharging
the
warm
water
onto
the
ground.
O
Publicidad
