Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
PREPARING
THE
UNiT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze"
pump action. If you do not plan to use the
pressure washer for more than 30 days, follow this
procedure:
I.
Flush detergent siphoning tube by placing filter into a
pail of dean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2.
Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect
spark plug wire
from spark plug.
3.
Empty pump of liquids by pulling engine recoil handle
about 6 times.This
should remove most liquid in pump.
4.
Use PumpSaver to prevent corrosion
build up and
freezing of pump.
5.
Store unit in a clean, dry area.
Protecting
the
Pump
To protect
the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE:
PumpSaver is available as an optional accessory. It
is not included with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected
from supply water. Read and
follow all instructions
and warnings given on the PumpSaver
container.
CAUTION
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
CAUTION
Always wear eye protection when using PumpSaver.
CAUTION
• Protect surfacesfrom dripping PumpSaver.
NOTE:
If PumpSaver is not available, draw RV antifreeze
(non-alcohol)
into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING
THE ENGINE
See the engine operator's
manual for instructions on how
to properly prepare the engine for storage.
O
Publicidad
