List Of Fault Codes - baltur BT 320 Guía Rápida

2 LIST OF FAULT CODES

Fault Code
0 Unknown fault (internal error)
1 Pre-ventilation signal is still active.
2 Parasitic light detected
3 Flame blow-off during ignition
4 Flame blow-off during operation
5 Flame signal does not appear during the first safety time
6 Flame signal extinguishes during stabilization time
7 Flame signal extinguishes during first safety time
8 Flame signal extinguishes during the second safety time
9 Flame signal does not appear during the safety time
10 Flame signal extinguishes during the safety time
11 Monitoring for parasitic light does not last the required 5 seconds
13 Main flame appears during ignition
103 Miscellaneous data invalid
105 Curve data are invalid or not available.
106 Parameters between both controllers are inconsistent Possible
cause of error: You have uploaded a normal data set (unprotected)
and an error occured during the data transfer. The dataset was
not transferred correctly.
107 Configuration is not valid see chapter 3 Assignment of
Configuration fault 107
120 Different operation modes on both controllers
121 Correction is out of range
141 Channel feedback changes too fast
151 Recirculation damper is deactivated
170 Short circuit of LDR flame detector
191 First monitoring band exceeded for to long
201 First monitoring band fall short for to long
211 Second monitoringband exceeded for to long
221 Second monitoring band fall short for to long
231 Fuel/air ratio control is blocked
241 Actuator doesn´t move, i.e. no position feedback
251 Actuator cannot find reference position
261 Actuator returns invalid position (difference to target position
too large)
271 Actuator position changes too fast, e.g. slip
281 Actuator feedback not correct
320 Open broken wire at firing rate input
321 Open broken wire at feedback channel
351 Invalid fuel change while burner is running
352 Invalid combination of fuel signals (no signals)
353 Invalid combination of fuel signals (several signals)
362 Fault shut-down due to a missing bruner maintenance
363 Smallest valid O2 value deceeded
371 Outpout for internal firing-rate is defective
372 Difference of the burner firing-rate values between main processor
and watchdog processor is too large
381 Deviation between main processor an watchdog controller too
large
391 Curve set has changed during programming
393 Emergency shut-down activated
D1
37 / 50
0006081511_201311
D2
Curve set / Fuel number
Parameter No.
Channel (x)
Channel (x)
Channel (x)
Channel (x)
Channel (x)
Channel (x)
Channel (x)
Channel (x)
Channel 0 = backward, 1 = forward
Channel
Channel
Channel
Channel
Channel (x)
Correction channel
Description