Betamotor RR 400 Manual De Instrucciones página 113

3
REPLACING THE OIL FILTER
1
Remove screw 1 and allow the oil to drain
2
into a container placed under the engine.
Remove the four screws 2 and take off the
two oil filter covers.
2
Using special seeger ring pliers, pull the
two filter elements 3 out of the crankcase.
Clean the oil filter covers, the sealing sur-
faces of the O-rings and the crankcase.
Check the oil filter cover O-rings for dam-
age and if necessary replace them.
3
Insert the long filter unit at the front and the
short filter unit at the back of the crank-
case. Grease the oil filter cover O-rings
4
and fit covers 4.
Fit screws 2 and tighten them at 6 Nm.
Tighten screw 1 at 8 Nm.
Remove screw fastener 5 from the clutch
cover and pour in 1.25 litres of fully syn-
thetic engine oil (MOTOREX COBRA
15W40).
WARNING
Before starting the engine, it is advisable
to rotate the engine (using the kickstart) to
allow the oil to spread evenly throughout
the system.
5
Start the engine and check the tightening
of all the screw fasteners and of the oil
filter covers.
Finally check the engine oil level and if
necessary top up.
GB
113