Publicidad
Warning
DANGER! Danger when opening up the tool, as live parts are exposed. Before opening, unplug the tool to ensure disconnection
from the mains. Before putting into operation, check power supply cord and connector as well as extension cable for electrical and
mechanical damage.
Incorrect use of the Hot Air Tool (eg. overheating of the material) can cause a fire and explosion hazard, especially near
DE
combus t ible materials and explosive gases. Do not apply to the same place for a long time. Heat can ignite flammable materials
EN
which are not in view.
IT
Fire and burn hazard! Do not touch the heating element housing and air nozzle when they are hot as they can cause burns.
FR
Let the tool cool down. Do not point the hot air flow in the direction of people or animals.
Before replacing a nozzle or storage after use, place the tool vertical down on its standing surface and allow it to cool down completely.
ES
If the Hot Air Tool switches off autonomously in operation (thermal relay), switch tool off or disconnect the power supply from mains.
PT
Before reusing, let the tool cool down.
NL
Automatic restart! The device is configured in such a way that it restarts automatically when switched on after a mains interruption
once the supply voltage returns. For this, the device sets itself to the temperature / air volume last set.
HY
TH
Caution
ZH
The voltage rating stated on the tool must correspond to the mains voltage.
JA
For personal protection on building sites we strongly recommend the tool be connected to a
MN
RCCB (Residual Current Circuit Breaker).
AR
The tool must be operated under supervision.
This tool may be used by children aged 8 or above and by persons with reduced physical, sensory or mental capabilities or
FA
lack of experience and knowledge if they are supervised or have been given instructions on how to use the tool safely and
KO
understand the hazards involved. Do not allow children to play with the tool. Children are not allowed to clean or carry out
maintenance work on the tool without supervision.
Protect tool from damp and wet.
Repairs should only be carried out by authorized service points. Restricted to use with original accessories and spare
parts.
4
Translations of the Original Operating Manual
Publicidad
