1. Connect the 8-pin connector supplied, into Location 1, on the back of the radio/
climate-control housing. (see Connection Legend)
Note: If this connector is not plugged in, the kit will not operate.
2. For manual climate control vehicles only, connect the 16-pin connector
supplied, into Location 3, on the back of the radio/climate-control housing.
(see Connection Legend)
3. Locate the factory wiring harness and antenna connector in the dash, and
complete all necessary connections to the radio.
4. Mount the completed assembly into the dash, and then reassemble the dash in
reverse order of disassembly, using the 99-7524B radio/climate panel.
Note: There are no existing holes for mounting the radio. New holes will need
to be made using (2) #8 x 1" Phillips screws supplied . The radio brackets will
rest on a shelf in the sub-dash. Be sure the radio is level and centered while
mounting the completed assembly into the dash opening.
5. Start the car and test all the climate control functions.
Note: The air recirculation light will be on at initial startup and will not go out
until using the climate controls for the first time.
99-7524B
Installing the 99-7524B
Connection Legend
(99-7524 radio housing diagram)
*Note: Location 2 will not be used in this application.
10
*Location 2
Location 3
Location 1