Kit Preparation
1. Mount the a/c vents, storage pocket,
hazard switch, and passenger air
bag indicator into the 7353 radio
trim panel.
2. Mount the start/stop switch or blank
plate depending on your application
into the 7353 radio trim panel.
Note: An airbag-light
blank plate and screws
are included for
non-US models.
(Figure A)
Note: If no switch is present
there are (2) #8 X 3/8" Phillips
truss head screws supplied to
mount the blank plate.
3. Install the (8) factory panel clips
onto the 7353 radio trim panel.
Continue to kit assembly
99-7353CH
ISO DIN head unit provision
with pocket
1. Mount the pocket to the radio
brackets with the (2) #8 X 3/8"
Phillips pan head screws supplied.
(Figure A)
2. Slide the head unit into radio
brackets and secure with screws
supplied with the unit. (Figure B)
3. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
4. Reassemble dash in reverse order
of disassembly.
3
Kit Assembly
(Figure A)
(Figure B)