Dash Disassembly; Kit Preparation - Metra 99-7504 Instrucciones De Instalación

Dash Disassembly

1. Unclip and remove the display trim
panel above the radio. (Figure A)
Tip: Open the glove box and start
in the middle of the panel, working
towards the drivers side first.
The last connection on the far
passenger side is a hook.
2. Remove (2) Phillips screws
exposed at the top of the radio,
and then unclip and remove the
radio. (Figure B)
Note: The display is attached to
radio brackets and will be removed
at same time as the radio.
3. Remove (2) Phillips screws on
the back of the display trim panel
securing the display, and then
DISPLAY REPLACEMENT POCKET
unclip and remove the display.
(Figure C)
Continued at kit preparation
MOUNTED IN DISPLAY TRIM PANEL
REAR VIEW - DISPLAY REPLACEMENT PANEL
HOOK
(Figure A)
(Figure B)
(Figure C)
99-7504
Display Brackets/Pocket
Assembly
Automatic Climate Control Vehicles
(2006-2009)
1. Using the (2) 3/8" X #10 bolts and
(2) #10 nuts, attach the display
retention brackets to the display.
2. Remove the (2) Phillips screws in
the sub-dash. (Figure A)
3. Mount the display into the sub-dash
using the screws removed in step 2.
Continued at kit assembly
Manual Climate Control Vehicles
Automatic Climate Control Vehicles
2004-2005
1. Using the (2) Phillips screws
removed in step 3 of dash
disassembly, secure the display
replacement pocket to the back of
the display trim panel. (Figure B)
Continued at kit assembly
2

Kit Preparation

(Figure A)
(Figure B)