Erreka RINO-I Guía Rápida De Instalación Y Programación página 15

A 0
Flashing light
1 Garage light time
2 Gate speed
3
Slowdown speed
6
Maximum entrapment current (each
value equivalent to 0.5A)
The digit D3 can be used to adjust
current to normal speed
The digit D4 can be used to adjust
current to slow speed
7
Closing photocell crossed during
standby (in automatic mode only)
8
Effect of pushbuttons (ST1, ST2) during
stand-by time (in automatic mode only)
9
Opening mode
b Using the EPS1 card connector
For parameters Ab02 and Ab03, use
the EPS1 card and bridge the network
input cable connectors instead of
disconnecting them from the network.
ç 0 Programming lock key
Be sure to remember any key used, for
future access to programming
1
Operations carried out (total counter)
2 Operations carried out (partial counter,
restarts with ST1 and ST2)
0 1
x
0 2
0...5. 0...9 03
0 1...9 03
0 1...9 03
0...9 0...9 00
0 0
0 1
0 2
x
0 0
0 1
0 2
x
0 1
0 2
x
0 3
0 0 x
0 1
0 2
0 3
X X 0000
X X
X X
No pre-warning, static output
With pre-warning, static output
59 = 59 secs; 2.5 = 2 min. 50 secs, etc
01: minimum speed (40Hz);
02: 45Hz, 03: 50Hz, 04: 55Hz, ...
09: maximum speed (80Hz)
01: minimum speed (21Hz);
02: 22Hz, 03: 23Hz, 04: 24Hz, ...
09: maximum speed (29Hz)
00: disabled;
01: disabled at normal speed and 0.5A at
slow speed;
10: 0.5A at normal speed and disabled at
slow speed; ...;
65: 3A at normal speed and 2.5A at slow
speed;...;
99: 4.5A at normal and slow speed
No effect
Immediate closing after crossing
Restart standby time
No effect
Cause immediate close
Restart stand-by time
Collective opening
Semi-automatic alternative shutdown
Automatic alternative shutdown (only in
automatic mode, F2 K 00
use for standard traffic light
use for brakes
NC contact with gate open (L1-COM) and
gate closed (L2-COM)
impulse 1 second Open (L1-COM) when
starting opening and Close (L2-COM) when
starting closing. Allows another board to be
activated
The preset option is 0000 (no key). If any
figure is changed, this is considered a key.
Select the required key (starting with D1)
using UP and DOWN. Press ESC to cancel or
ENTER to confirm and move to D2, and so
on.
Indicates the hundreds of cycles completed
(for example, 68 indicates 6,800 cycles
completed)
Indicates the hundreds of cycles completed
(for example, 68 indicates 6,800 cycles
completed)
15