Create Or Edit A Dispense Program - Manostar Compulab 3 Manual De Operación

CREATE OR EDIT A DISPENSE PROGRAM

To create a new dispense program, ensure that the console displays the PROGRAM MENU. If any other menu appears,
press the BACK key until the PROGRAM MENU is displayed.
Press the arrow under NEW to create a new program or press the arrow under EDIT to select a program to revise.
Follow the flowchart in Figure 11 to create or edit a dispense program.
REQUIRED PARAMETERS
ENTER PUMP TYPE,
TUBE SIZE, AND RATE
ENTER VOLUME
AND DIRECTION
ENTER UNITS
FOR VOLUME,
ENTER GRAM OR
KILOGRAM IF USING
A BALANCE
OPTIONAL PARAMETERS
ENTER ACCEL AND DECEL
ENTER NUMBER OF CYCLES;
TOGGLE MANUAL OR AUTO
(0 CYCLES IS NO LIMIT)
ENTER DELAY TIME BETWEEN
AUTO CYCLES
ENTER BEEP TIME AND NO-DRIP
INPUT A PROGRAM NUMBER
(1 – 30)
AND PRESS ENTER TO SAVE
PRESSING ENTER WITHOUT ENTERING
A NUMBER RUNS THE PROGRAM.
( REFER TO RUNNING A DISPENSE PROGRAM
PROGRAM MENU LINKED:NONE
NEW EDIT:##
)
Figure 11. Dispense Menus
LOAD LINK
11
PUMP
#1