Manostar Compulab 3 Manual De Operación página 18

For pump programs, all linked pump drives begin when the RUN arrow key is pressed or the external start/stop contact
closure is closed for any linked pump. The pumps continue running until the CANCEL/STOP or STOP ALL key is
pressed or until the external start/stop contact closure is opened for any linked pump. All pumps pause simultaneously. All
pumps start over or resume simultaneously when the appropriate arrow key is pressed. An external signal resumes all
pumps.
For dispense programs, all linked pump drives begin when the RUN arrow key is pressed or the external start/stop
contact is momentarily closed for any linked pump. The pumps continue running until the CANCEL/STOP or STOP ALL
key is pressed or until the external start/stop contact signal is momentarily closed. All pumps pause simultaneously. All
pumps start over or resume simultaneously when the appropriate arrow key is pressed. Momentarily closing the external
start/stop contact also resumes all pumps. If not interrupted, each pump continues to run until the programmed volume is
dispensed. For programs with multiple cycles, each pump must complete a cycle, then a new cycle simultaneously starts
all linked pump drives.
Use the following procedure to link pump drives. Ensure that the PROGRAM MENU is displayed. If it is not, press BACK
until the following display is shown:
1. Press the arrow key under LINK. The following display appears:
2. Press the arrow key under the pump you wish to link. The selected pump number appears on the top line.
3. Select the additional pumps to be linked. Their numbers appear on the top line.
NOTE: To deselect a pump, press the arrow key under the pump, and its number is removed from the linked pumps.
4. Press ENTER to accept the linked pumps.
Running Programs
NOTE: Before continuing, be sure that the pump heads are mounted and that the correct size tubing is properly loaded
and routed to the correct locations.
If the pump number shown in the upper right corner of the display is not the pump that is going to run the program, you
will have to reload the program to run it on that pump. The program stays in memory, assigned to the active pump when
loaded. Change the pump number by pressing PUMP# on the control keypad. When the correct pump number is
displayed, refer to LOADING A PROGRAM, press the arrow key under PROGRAM, and load the desired program.
NOTE: Ensure that the number of pump heads mounted on the pump drive is the same as the number of heads the
program is designed to run. If the number of heads do not agree, the program will not operate properly.
Refer to Figure 13, Figure 14, or Figure 15 to run a pump program, a dispense program, or a dilute program.
PROGRAM MENU LINKED:NONE
NEW EDIT:##
LINKED PUMPS:NONE
PUMP1 PUMP2
LOAD LINK
ENTER CONTINUES
PUMP3 PUMP4
14
PUMP
#1
PUMP