Saving A Program; Loading A Program; Operating Procedures - Manostar Compulab 3 Manual De Operación

SAVING A PROGRAM

After all the required parameters are entered, you should save the program. Up to 30 programs in any combination of
pump, dispense, and dilute can be stored at one time. If the SAVE MENU is not shown, go to the PROGRAM MENU,
edit the program you want to save, and press ENTER until the following display appears:
1. Enter a number between 1 and 30 and press ENTER to save the program. If there is a program saved under the
number entered, the following display appears:
2. Press the arrow key under YES to overwrite the saved program with the current one, or press the arrow key under
NO to go back to the SAVE MENU to give the program a different number.

LOADING A PROGRAM

To load an existing program, ensure that the console displays the PROGRAM MENU. If any other menu appears, press
the BACK key and then the arrow key under PROGRAM so the PROGRAM MENU is displayed.
Ensure that the pump number shown in the upper right of the display is the pump that will run the loaded program. If it is
not the correct pump, press PUMP# on the control keypad until the correct pump number is displayed.
NOTE: If you do not know the number of the program you want to load, press the arrow key under LOAD, and proceed
to step 4. If you know the number of the program to load, continue with step 1.
1. Press the arrow key under LOAD, input the program number, and press ENTER. The program loads into memory.
Refer to OPERATING PROCEDURES to run the program.
2. If there is no program saved under that number, the following display appears:
3. Press ENTER to return to the LOAD menu.
4. To scroll through the saved programs, press the arrow key under DECREMENT or INCREMENT until the desired
program is located. Press ENTER to load the program. The program loads into memory. Refer to OPERATING
PROCEDURES to run the program.

OPERATING PROCEDURES

Before performing any of the procedures in this section, be sure that the correct size tubing is properly loaded. Refer to
SETUP to mount the pump heads and install the tubing.
You may run the same program to four pumps, or different programs for each pump.
A program designed for a pump drive with two heads will run on a pump drive with one head mounted, but the flow rate
will be only half of the expected rate. A program designed for a pump drive with one head will run on a pump drive with
two heads mounted, but the flow rate will be double the expected rate.
Linking Pumps
For pumping or dispensing operations, two or more pump drives may be linked so that they operate and are controlled
simultaneously. All linked drives start with a single key press or by one external signal. All linked drives must be set up to
run the same type of program.
NOTE: Dilute programs cannot be linked.
SAVE PROGRAM
PROGRAM NUMBER:0
PROGRAM ## IS IN USE.
YES
PROGRAM MENU LINKED:NONE
NEW EDIT:##
NO PROGRAM AT THIS LOCATION.
ENTER CONTINUES.
ENTER CONTINUES #1
0 = NOT SAVED
OVERWRITE?
NO
LOAD LINK
13
PUMP
PUMP
PUMP
#1
PUMP