Gree GEH09AA-K6DNA1F/I El Manual Del Propietario página 15

How to use the remote control to operate the unit
10
TEMP:
Press this button, could select displaying the indoor setting temperature or indoor ambient
temperature.When the indoor unit firstly power on it will display the setting temperature,
if the temperature's displaying status is changed from other status to"
ambient temperature, 5s later or within 5s, it receives other remote control signal that will
return to display the setting temperature. if the users haven't set up the temperature
displaying status,that will display the setting temperature.
11 QUIET:
Press this button, the Quiet status is under the Auto Quiet mode (display
and Quiet mode (display "
after powered on, the Quiet OFF is defaulted. Note: Under the Quiet mode (Display "
fan speed is not available.
12 CLOCK :
Press CLOCK button, blinking
Holding down either button above 2 seconds increases or decreases the time by 1 minute every 0.5
second and then by 10 minutes every 0.5 second. During blinking after setting, press CLOCK button
again to confirm the setting,and then
13 T-ON / T-OFF:
Press T-ON button to initiate the auto-ON timer. To cancel the auto-timer program, simply press this
button again.
After press of this button,
5 seconds,press + or - butt on to adjust the time value.Every press of either
setting by 1minute. Holding down either button rapidly changes the time setting by 1 minute and then
10 minutes.Within 5 Seconds after setting,press TIMER
Press T-OFF button to initiate the auto-off timer. To cancel the auto-timer program, simply press the
button again.TIMER OFF setting is the same as TIMER ON.
TURBO:
14
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset
temperature in the shortest time. In COOL mode, the unit will blow strong
speed. In HEAT mode, the unit will blow strong heating air at super high fan speed.
15
LIGHT:
Press LIGHT button to turn on the display's light and press this button again to turn off the display 's
light. If the light is turned on ,
WiFi:
16
P e r s s " W i " i F b t u
icon will be displayed on remote controller; Under status of unit off, press "MODE" and "
simultaneously for 1s, WiFi module will restore to factory default setting.
● This function is only available for some models.
Combination of "+" and "-" buttons: About lock
17
Press " + " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is
locked, is displayed. In this case, pressing any button,
" singal) and Quiet OFF (there is no signal of "
. Within 5 seconds,pressing + or - button adjusts the present time.
disappears and "ON "blinks .00:00 is displayed for ON time setting.Within
is displayed. If the light is turned off,
o t n o t u t n r o n r o u t n r o
will be constantly displayed.
ON button to confirm.
f f W i i F u f n t c o i . n W h e n
11
OPERATION INSTRUCTIONS
",displays the
" " and "Auto"
" displayed),
button changes the time
cooling air at super high fan
disappears.
W i i F u f n t c o i n s i u t n r e d
blinks three times.
signal)
" signal), the
WiFi
o , n h t e " "
WiFi
" buttons