Franklin Electric SUBDRIVE UTILITY Manual De Instrucciones página 19

Risk of damage to VFD
Follow all wire routing and grounding instructions carefully. Inductive currents caused by paral-
lel wiring, or close proximity between high voltage and control wiring can cause unexpected
behaviors.
• Do not run input power and motor wires in the same conduit.
• Do not run motor wires from multiple VFDs in common conduit.
• Do not run control wiring parallel with high voltage wiring.
• Do not install a magnetic contactor or disconnect in the motor circuit.
• Do not run VFD wiring parallel with house or out-building wiring.
• Do not use aluminum wires for VFD connections.
• Do not use with a Ground Fault Circuit Interrupter (GFCI) between breaker panel and motor.
• All wiring must comply with the National Electrical Code and local codes.
• Improper splicing or damage to motor cable insulation may expose the conductor(s) to
moisture and can produce motor cable failure.
Branch Circuit Protection
Integral solid state short circuit protection does not provide branch circuit protection. Branch circuit
protection must be provided in accordance with the National Electrical Code and any additional
local codes, or the equivalent. Drive shall be protected by fuse or inverse-time circuit breaker only,
rated 300 V, and a maximum 300% of full load motor output current rating as noted in the table
below.
Fuse/Circuit Breaker and Wire Sizing
Model Input Motor HP
Voltage
115 1/2 (0.37 kW)
230 1/2 (0.37 kW)
SubDrive
230 3/4 (0.55 kW)
Utility
230 1.0 (0.75 kW)
230 1.5 (1.1 kW)
1
Based on a 3% voltage drop.
90 C Insulation only.
*
Note: SubDrive Utility minimum breaker amps may be lower than AIM Manual specifications
because of the soft-starting characteristic of the drive.
,
or malfunction can occur.
Fuse/Breaker AWG Copper Wire Sizes, 75° C Insulation, and Panel to Drive Cable
Amps
14
*
15 40
15 130
15 130
*
20
70
25 –
Lengths (in feet)
12 10 8 6
60 100 155 245
205 340 525 835
150 250 390 620
*
185 285 450
110
– 140 215 340
INSTALLATION AND SETUP
Electrical Installation
1
4 3 2 1
390 485 635 805
1315 1635 2150 2720
975 1210 1595 2020
715 885 1165 1475
540 670 880 1115
19