Product Information; Description; Features - Franklin Electric SUBDRIVE UTILITY Manual De Instrucciones

PRODUCT INFORMATION

Description

The Franklin Electric SubDrive Utility is a variable frequency drive (VFD) designed to control and
protect 2-wire, single-phase motors with 115 or 230 volt ratings, enhancing pump performance for
residential and light commercial water system applications. When used with Franklin Electric
motors ranging from 1/3 to 1 ½ HP, the SubDrive Utility drives a motor and pump at variable speeds
to maintain constant water pressure, even as user demands (water flow) change.
The SubDrive Utility is also compatible with single-phase 2-wire submersible
split capacitor (PSC) motors, above-ground booster pumps, and jet pumps
with overload current ratings from 4.6 A to 13.1 A. *
The SubDrive Utility is designed to convert a conventional pump system to a
variable speed constant pressure system by simply replacing the pressure
switch.

Features

Configuration
• Compatible with submersible and surface pumps and motors *
• No programming required with easy DIP switch setup
• Pressure sensor or transducer included for ease of installation
• Additional input for optional transducer for more precise control
• Works with small pressure tanks or existing larger tanks
Operation
• Three LED indicators for system status and troubleshooting
• 35 – 63 Hz frequency range with submersible motors
• 40 – 60 Hz frequency range with surface motors
• Accessory filtering available to remove radio frequency interference
Protection
• Protection against short circuit, under-load, overload, overheat, under-voltage, over-voltage,
surges, open circuit
• Broken-pipe detection
• User-defined under-load sensitivity
• Soft-start feature prevents water hammer and increases motor life
Communication
• USB port allows for easy firmware updates
* Firmware version 1.3.1 or later is required to operate submersible PSC or surface pumps.
PRODUCT INFORMATION
Description
7