Maintenance; Changing The Battery; Storage; Cleaning - Gossen MetraWatt Metraclip 72 Manual De Instrucciones

For maintenance, use only specified spare parts. The
manufacturer will not be held responsible for any
accident occuring following a repair done other than
by its After Sales Service or approved repairers.

6.1 Changing the battery

The clamp must be disconnected from any external electrical
source and must not be in contact with the cable.
Set the switch to OFF
Slide a screwdriver into the slot at the top of the battery
cover (rear of the clamp) and push the battery cover
upwards.
Replace the used battery by a 9 V battery, type LF22;
observe the polarities.
Install the battery in its housing, then install the battery
cover.

6.2 Storage

If the clamp is not used for a period of more than 60 days,
remove the battery and store it separately.

6.3 Cleaning

The clamp must be disconnected from any external
electrical source and must not be holding the cable.
Clean the unit and jaws with a cloth slightly moistened with
soapy water. Clean off with a damp cloth. Then dry quickly
with a cloth or pulsed air.
Do not splash water onto the clamp.
Keep the gap between the jaws in a state of perfect
cleanliness.

6.4 Repair and Replacement Parts Service

DKD Calibration Lab and Renatl Instrument Service
When you need service, please contact :
GOSSEN METRAWATT GMBH
Service Center
Thomas-Mann-Straße 20
90471 Nürnberg
Phone +49-(0)-911-8602-0
Fax
E-Mail service@gmc-instruments.com
This address is only valid in Germany. Please contact our
representatives or subsidiaries for service in other countries.

6.5 Product Support

When you need support, please contact :
GOSSEN METRAWATT GMBH
Product Support Hotline
Phone +49-(0)-911-8602-112
Fax
E-Mail support@gmc-instruments.com

6. MAINTENANCE

Germany
-48-(0)-911-8602-253
+49-(0)-911-8602-709
44