Oven Assembly - Blodgett DFG-50 Manual De Instrucciones

Installation

Oven Assembly

NOTE: This appliance shall be installed in accor-
dance with current regulations and used
only in a well-ventilated space. Refer to the
instructions before installing and using
this appliance.
NOTE: Installation must be performed by a quali-
fied installer only.
LEG ATTACHMENT
10 cm legs
1. Lay the oven on its back.
2. Screw the legs into the holes in the oven cor-
ners. Tighten the hex nut at the top of each leg
3. Tip the oven up on the legs.
4. Turn the adjustable leg feet to level the oven.
Figure 1
15 cm, 18 cm and 64 cm legs
1. Lay the oven on its back.
2. Align the threaded stud in each leg with the
nut inside each bottom corner. Turn the legs
clockwise to tighten.
3. Align the holes in each leg plate with the holes
in the oven frame. Secure each leg with two
1/2" bolts.
NOTE: See Caster Installation if applicable.
4. Tip the oven up on the legs.
5. Turn the adjustable leg feet (or casters) to level
the oven.
15 cm Adjustable Legs
4
Figure 2