Caster Assembly - BLUE EMBER GRILLS FGQ65079 Manual Del Usario

If you purchased your barbeque pre-assembled, please refer to this page for caster & tank caddy
assembly. The assembly instructions for the door and shelves are located on page 18. Otherwise please
proceed to page 19 for full assembly procedures.
TOOLS REQUIRED:
STEP 1
Install the front casters using 2 people. One to tilt
thebarbeque back to allow the second person to placethe
ice/wine bucket supplied with your barbequeupside down
under the front edge of the base panfor support. The front
casters are then installedusing a wrench as shown.
ICE/WINE
BUCKET
APPROXIMATELY 15 deg. angle
Please refer to FIG. 2 page 19 & FIG. 12 page 29 in this manual to assemble the Tank Caddy on this barbeque.
Please read all assembly pages for important warnings, providing power,and tank assembly instructions.
PRE-ASSEMBLED BARBEQUE ASSEMBLY 1 OF 2
• Adjustable wrench

CASTER ASSEMBLY

CAUTION:
DO NOT TILT BARBEQUE TOO FAR,
AS PERSOAL INJURY MAY OCCUR.
TANK CADDY ASSEMBLY
IMPORTANT:
STEP 2
Lock the front casters. Install the rear casters using2 people.
One to tilt the barbeque backward to allow thesecond person
to place the ice/wine bucket suppliedwith your barbeque
upside down under the rear edgeof the base pan for support.
The rear casters are theninstalled using a wrench as shown.
STEP 1
Lock front casters and place
one foot in front of base to
steady barbeque when
tilting.
APPROXIMATELY 15 deg. angle
22
• #2 Phillips screwdriver
NOTE:
When tilting the barbeque forward
place one foot in front of the base pan
to help keep the bottom from moving.
STEP 2