Controls A Nd Features; Ignition Switchmodule - Cub Cadet Z-Force S 48 Manual De Instrucciones

Controls a nd Features
4
f J_
Parking Break
Eric ement Lever
Ignition
Switch
Module
I
Hour Meter/
indicator Panel
Fuel Tank Ca
Reverse Pedal
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.
DeckLift Pedal
Figure 4=1
Ignition SwitchModule
WARNING! Never
leave a running
machine unattended.
Always disengage
PTO, set parking
brake, stop engine
The deck lift pedal is located near the front of the tractor on the
left of the foot platform and is used to raise and lower the mower
deck. The deck lift pedal has 17 positions including the transport
position.
Push the pedal forward and rock back to lock into the transport
position, locking behind the notch on the front of the index
plate. Remove and replace the lock pin into the desired height
index hole, then push pedal forward and rock forward to unlock
and slowly allow the pedal to move back until it reaches the lock
pin.
and remove key to
prevent unintended
starting.
To start the engine, insert the key
into the ignition switch and turn
clockwise to the START position.
©
Release the key into the NORMAL MOWING MODE position once
the engine has fired.
To stop the engine, turn the ignition key counterclockwise to the
STOP position.
CAUTION:
Prior to operating the tractor, refer to
both Safety Interlock Switches and Starting The
Engine in the Operation section of this manual for
detailed instructions regarding the Ignition Switch
Module and operating the tractor in REVERSE
CAUTION MODE.
11