Publicidad
Idiomas disponibles
Idiomas disponibles
4.
5.
Turn the water on.
While sitting
in the operator's
position
on the tractor, start
the engine
and place the throttle
lever in the FAST (rabbit)
position.
6.
Move the tractor's
PTO (Blade Engage) into the ON position.
7.
Remain in the operator's
position
with the cutting
deck
engaged
for a minimum
of two minutes,
allowing
the
underside
of the cutting
deck to thoroughly
rinse.
8.
Move the tractor's
PTO (Blade Engage) into the OFF
position.
9.
Turn the ignition
key to the STOP position
to turn the
tractor's engine
off.
10.
Turn the water off and detach the hose coupler
from the
water port on your deck's surface.
11.
Repeat step 4-10 on the opposite
side of the cutting
deck.
After cleaning your deck with the Smart Jet
TM
system, return to
the operator's
position
and engage the PTO. Keep the cutting
deck running
for a minimum
of two minutes,
allowing
the
underside
of the cutting
deck to thoroughly
dry.
Lubrication
WARNING!
Before lubricating,
repairing,
or
inspecting,
always disengage
PTO, set parking
brake, stop engine and remove
key to prevent
unintended
starting.
Front Wheels
Each of the front wheel spindles and rims is equipped
with a
grease fitting.
See Fig. 6-3. Lubricate
with a No. 2 multi-purpose
grease applied
with a grease gun after every 25 hours of tractor
operation.
f
_._
\_
............i
Grease
Fittings
_
DeckSpindle
Grease fittings
can be found on each deck spindle.
See Fig. 6-4.
Lubricate
with 251H EP grease or an equivalent
No. 2 multi-
purpose
lithium
grease. Using a grease gun, apply two strokes
(minimum)
or sufficient
grease to the spindle
shaft.
f
Figure 6-4
WARNING!
Never exceed the maximum
inflation
pressure shown on the sidewall
of the tire.
Refer to the tire sidewall
for exact tire manufacturer's
recommended
or maximum
psi. Do not overinflate.
Uneven tire
pressure could cause the cutting
deck to mow unevenly.
k_
j
Figure 6-3
Pivot Points & Linkage
Lubricate
all the pivot points on the drive system, parking
brake
and lift linkage at least once a season with
light oil.
SECTION 6 --
MAINTENANCE
& ADJUSTMENTS
21
Publicidad
