Publicidad
Idiomas disponibles
Idiomas disponibles
PTO(PowerTake-Off) Switch
The PTO switch
is located
on the LH console to
the left of the operator's
seat.
The PTO switch
operates
the electric
PTO
clutch mounted
on the bottom
of the engine
crankshaft.
Pull the switch
knob upward
to
engage the PTO clutch, or push the knob
downward
to disengage
the clutch.
The PTO switch
must be in the "disengaged"
position
when starting
the engine.
PTO
•
t
0
-I
Transmission BypassRods(Not Visible)
The transmission
bypass rods (one for each the RH and LH
transmission)
are located
on the rear of the tractor, just inside
each rear wheel,
below the fuel tank and the storage tray.
When engaged,
the two rods open a bypass within
the
hydrostatic
transmissions,
which allows the tractor
to be pushed
short distances
by hand.
CAUTION:
Never tow your tractor. Towing
the
tractor
with the rear wheels on the ground
may
cause severe damage
to the transmissions.
CupHolder
The cup holder
is located
on the LH console to the left of the
operator's
seat.
StorageTray
The storage tray is located
at the rear of the LH console.
SeatAdjustment Lever
The seat adjustment
lever is located
below the front/left
of the
seat. The lever a Ilows for adjustment
of the fore to aft position
of the operator's
seat. Refer to the Maintenance
& Adjustments
section for instructions
on adjusting
the seat position.
FuelTankCap
The fuel tank cap is located
on the LH console. Turn the fill cap to
remove. Always re-install
the fuel cap tightly
onto the fuel tank
after removing.
_
ARNING!
Never fill the fuel tank when the engine
is running.
If the engine
is hot from recently
running,
allow to cool for several minutes
before refueling.
Highly flammable
gasoline could splash onto the
engine
and cause a fire.
HourMeter/IndicatorPanel
The hour meter/indicator
panel is
located
on the LH console to the left of
the operator's
seat.
HourMeter Features
The hour meter records the hours that
the tractor
has been operated
in the
digital
display (tenths
of an hour-
right
most digit).
NOTE:The
hour meter is activated
whenever
the ignition
switch
is turned
to the "ON" position.
Keep a record of the actual hours
of operation
to assure all maintenance
procedures
are completed
according
to the instructions
in this manual and the engine
manual.
When key is turned
to the "ON" position,
the battery
indicator
light briefly illuminates
and the battery
voltage
is briefly
displayed.
The display then changes
to the accumulated
hours.
The Indicator
Monitor
will also remind
the operator
of
maintenance
intervals
for changing
the engine oil. The LCD
will alternately
flash, "CHG" ; "OIL" and the recorded
hours for
five minutes
after every 50 hours of recorded
operation.
The
maintenance
interval
lasts for two hours (from 50-52,100-102,
150-152, etc.). The LCD will flash as described
for five minutes
every time the tractor's
engine is started
during
this maintenance
interval.
Follow the oil change intervals
provided
in the engine
manual.
12 I
SECTION 4--
CONTROLS AND FEATURES
Publicidad
