Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the DeckWheels
Move the tractor
on a firm and level surface, preferably
pavement,
and proceed
as follows
1.
Select the height position
of the cutting
deck by placing
the deck lift pedal in the normally
desired mowing
height
setting.
2.
Check the deck wheels for contact
or excessive clearance
with the surface below. The deck wheels should
have
between
1/4-1/2" clearance above the ground.
3.
If the deck wheels have excessive clearance
or contact
with
the surface, adjust as follows:
a.
Raise the deck lift pedal to its highest
setting.
b.
Remove the front and rear deck wheels by removing
the lock nuts and shoulder
bolts which secure them
to the deck. See Fig. 6-7.
f
Deck Wheel
Figure 6-7
C.
d.
Place the deck lift pedal in the desired mowing
height setting.
Reinsert the shoulder
bolts (with each gauge wheel)
into the index hole that leaves approximately
1/2-inch between
the bottom
of the wheel and the
pavement.
Parking BrakeAdjustment
If the tractor
does not come to a complete
stop when the brake
lever is completely
engaged,
or if the tractor's
rea r wheels can
roll with the parking
brake applied
(and the hydrostatic
relief
valve open), the brake is in need of adjustment.
See your Cub
Cadet dealer to have the brake properly
adjusted.
Adjusting the Seat
To adjust the position
of the seat, push the seat adjustment
lever
to the left. Slide the seat forward
or rearward
to the desired
position;
then release the adjustment
lever. Make sure seat is
locked into position
before operating
the tractor. See Fig. 6-8.
f
,%
Figure 6-8
SECTION 6 --
MAINTENANCE
& ADJUSTMENTS
23
Publicidad
