Lincoln Electric POWER MIG 180 DUAL Manual Del Operador página 13

POWER MIG 180 DUAL
TABLE B.1
Wire Diameter & Type
.025"(0.6mm) MIG wire
.030"(0.8mm) MIG wire
.035"(0.9mm) MIG wire
.030"(0.8mm) flux-cored
.035"(0.9mm) flux-cored
.045"(1.1mm) flux-cored
(See Figure B.6 for the following Items.)
13. CIRCUIT BREAKER – If the rated input current of the machine
is exceeded this circuit breaker will trip. Press to reset.
14. GAS INLET – Shielding gas connects to this inlet.
15. POWER CORD CONNECTION - Ensure power cord is
disconnected from input voltage supply prior to connecting or
removing the cord from the machine. Connect the circular
connector present on either input cord (120V or 230V) to the
receptacle on the back of the machine. The power cord
connector is secured to the receptacle by rotating the
connector's coupling ring clockwise, until the coupling ring
latches on to the receptacle. Use only the appropriate (120V
or 230V) power cords supplied by the Lincoln Electric
Company.
DRIVE ROLL AND WIRE GUIDES
Drive Roll
.025"/.030" (0.6mm/0.8mm)
Smooth Drive Roll
.035"(0.9mm)
Smooth Drive Roll
.030"/.045" (0.8mm/1.1mm)
Knurled Drive Roll
.030"/.045" (0.8mm/1.1mm)
Knurled Drive Roll
B-4
Drive Roll Part
Inner Wire Guide
Number
KP2529-1
.025"-.035"
(0.6mm-0.9mm)
Steel Wire Guide
KP2529-2
KP2529-3
.045" (1.1mm)
KP2529-3
Steel Wire Guide
FIGURE B.6
13 14 15
OPERATION
Inner Wire Guide
Part Number
KP2531-1
KP2531-2