Stryker 6393 Manual De Operaciones página 24

English
Installing the wall plate (Continued)
EN
2. Using the dimensions shown in
attach.
Note: When installing the wall plate for the Stryker Model 6371 cot fastener with the long rail assembly option
(6362-021-000), measure 33 in. for the horizontal dimension and 4 1/16 in. for the vertical dimension. The Stryker
Model 6371 cot fastener with the long rail assembly option is only compatible with the extended head section
assembly (9996-390-200).
14-5/8"
(37,1 cm)
C
A Wall of vehicle
Antler floor plates
B
C Rear of ambulance
D Cot center line
3. Cut two 1 in. x 2-1/2 in. x 9/16 in. deep recessed openings (A) into the floor centered over the locating holes
(Figure 1-16 on page
1-18
Installation
(Figure 1-15 on page
2-5/8"
(6,6 cm)
3-5/8""
(9,2 cm)
G
6-1/2" (16,5 cm)
4-5/16" (10,9 cm)
Figure 1-15: Wall plate installation locations
1-19).
1-18), locate and drill the points where the floor plates will
A
D
E
80.000 (Ref.)
(203 cm)
37-3/8"
(94,9 cm)
H
Cot perimeter
E
F Cot head end
Wall mounting bracket
G
H Floor of vehicle
6370-109-005 REV C
B
F
24.000
(Ref.)
(61 cm)
1-1/8"
(2,9 cm)
6-1/8"
14-15/16"
(15,6
(37,9 cm)
cm)
www.stryker.com