Stryker 6393 Manual De Operaciones página 30

English
Adjusting the rail assembly (Continued)
EN
5. Tighten the mounting screws until the rail clamp is drawn firmly against the support bracket.
6. Push the rail handle (E) forward until the release button engages and the jaws lock in the open position.
7. Guide the cot into the fastener at a slight angle by connecting the loading wheels with the antler one at a time
(Figure 1-24 on page
WARNING
Do not use hand or fingers to press the release button when the rail jaws are open. The rail clamp fastener closes
with a strong spring action.
8. Move the foot end of the cot sideways until the cot post enters the rail jaws and presses the release button. The rail
jaws will close, locking the cot securely in position.
Note: Cot bedding may prevent attendants from seeing the rail jaws close around the cot post. Make sure that the
cot is locked into the fastener by firmly pulling side to side on the foot end of the cot.
9. Use one hand to push the rail handle forward far enough for the jaws to release the cot post. With the other hand,
grasp the cot and roll it away from the rail.
E
A
B
C
D
E
F
1-24
1-25).
B
B
E
E
Figure 1-23: Adjusting the rail assembly
Operation
D
D
A
A
D
Rail clamp
Rail assembly
Clamp jaws
Adjustment limit label
Rail handle
1" maximum adjustment
6370-109-005 REV C
C
C
Adjustment Limit Lab el
F
H
G
I
www.stryker.com