Stryker 6393 Manual De Operaciones página 26

English
Installing the wall plate (Continued)
EN
6. Using four 5/16 in. diameter socket head cap screws (E) (not supplied), anchor the wall bracket (F) through the 11/
32 in. diameter holes (G) to the wall (H)
Note: A steel backing plate (or equivalent) (J) (not supplied) is required for added support
20).
CAUTION
Do not use a screw smaller than the 5/16 in. diameter specified to anchor the wall plate.
Figure 1-18: Wall plate bracket and steel backing
7. Position the antler over the floor plates and fasten the antler (A) with the red knobs (B)
Notes
• Use the additional mounting holes in the antler bracket to position the antler for the Model 6370/6377/6378
floor mounted cot fastener systems.
• The red knobs that fasten the antler assembly to the patient compartment floor plate are not compatible with
the universal floor plate. See the Universal Floor Plate Installation Instructions for floor plate installation.
8. Position the rail assembly (C) on the wall mounting bracket (D)
9. Install the four Nylock hex nuts (E) and four 5/16−18 x 2 in. socket head cap screws (F) to attach the rail clamp (G)
to the rail assembly
1-20
Installation
(Figure 1-18 on page 1-20)(Figure 1-19 on page
(Figure 1-21 on page 1-21).
6370-109-005 REV C
1-20).
Figure 1-19: Wall plate bracket and locating points
(Figure 1-20 on page
(Figure 1-21 on page 1-21).
(Figure 1-18 on page 1-
1-21).
www.stryker.com