INSTALLATION AND START-UP
•
Check that the master switch is turned to "OFF" and that
the water filter is fitted into the pump's inlet pipe.
•
Screw the snap connection into place by hand, without
the aid of tools.
•
Connect the water supply hose to the snap connection.
The hose must have an inside diameter of at least 13
mm (1/2").
•
Connect the high pressure hose to the pump's outlet
pipe. Press the high pressure hose coupling fully down
and then screw into place by hand without the aid of
tools.
•
Connect the high pressure hose to the gun using 2
spanners: one to hold the gun nipple still, and the other
to turn the nut of the high pressure hose.
•
Turn the water tap fully on. The water temperature abso-
lutely must be below 40°C.
IMPORTANT: The washer machine has to operate with
clean water in order to avoid any damages to the washer
machine itself.
•
Release the gun safety catch and keep the trigger pres-
sed, allowing the water to flow until all the air has been
expelled.
•
Fit the lance into the gun.
Connect the plug to the power socket.
To start the machine, press the gun trigger and at the
same time turn the master switch to "ON".
FILLING UP
Fill up the tank with the fuel indicated on the technical data
plate (fig. 3).
Avoid that the tank is empty when the machine is running in
order not to damage the fuel pump.
Incorrect fuel shall not used as they as provide hazard.
Fill up the detergent tank with the suggested products, sui-
table for the kind of washing to be carried out (fig. 4).
ATTENTION: make use only of liquid detergent, do not
absolutely use acid or too much alkaline products.
We suggest you to make use of our products, which
have been studied for the use with washer machines.
1543Rev01 Man XTR 14l_multi.indd 17
Ref. 3
Ref. 5
1
2
GB
Ref. 4
17
30-11-2009 18:14:47