Electronic Circuit Assembly; Door Panel Fixation - golmar 2PLUS Manual De Instalación

54
F
ixing the door panel into the embedding
box.
To hold the door panel on the embedding box,
insert the hinge springs into the embedding
box bolts as shown.
To place the module El516 (or EL 512),
center the hole on the upper side of the module cover with the corresponding
hole in the embedding box.
Lean the circuit on the lower flanges and screw it to the embedding box. In such case there are more
modules of the same type, repeat this procedure further below, or on the next box.
DOOR PANEL INSTALLATION
Choose a direction to open the door panel; this selection
should facilitate the door panel wiring.
The opening direction is determined by the location of both
hinge springs, that have to be introduced through the clips
which are found at the end of the headers as it is shown
in the picture. For example, if the springs are placed on the
two clips of the lower header, the door pannel will open down-
wards; if they are placed on the right clips of both headers, the
door panel will open to the left.
S
Insert the sound module in the grille module.
For a proper assembly, align the light
push button and the microphone of the
sound module with its own holes in the
grille module.
ound module assembly.