Placing The Nameplate Labels; Push Button Wiring - golmar 2PLUS Manual De Instalación

DOOR PANEL INSTALLATION
P
lace the nameplate label of the push buttons.
Twist the call wires as shown. The call wires should
be connected to the sound module El520 or to
the corresponding push buttons encoder.
Open the label holder.
For a quality finish, pass the wires through the hole
arranged on the nearest module holder.
It is advisable to use wires with sections between
0,1 and 0,25mm .
VERY IMPORTANT: Link the push buttons common
terminal of the several push buttons modules. The
push buttons of the same module are linked from
factory. This wire must be connected to the CP
terminal of the sound module EL520 and to the cor-
responding CP terminal of the encoder circuit (if there is)
Place the label
and close.
P
ush button wiring.
2
55