Publicidad
Idiomas disponibles
Idiomas disponibles
TO iNSTALL SHIFTER LEVER KNOB
@ Thread the shifter lever knob onto the threaded end
of the shifter lever until it is snug against the hex nut
and the lip is pointed toward the engine. Tighten the
hex nut against the bottom o! the shift lever knob (See
Fig. 6).,
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables, Fig_7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
before you use your snow thrower.
For instructionson checking or adjusting the control
cables, see ToAdjust Clutch Control Cables paragraph on
page 20.
TO ASSEMBLE
SNOW CHUTE
•
Remove three carriage bolts, flatwashers, and nuts
from snow chute flange.
e
Position snow chute on snow chute flange and align
the three holes in the snow chute with holes in snow
chute flange.
e
Replace carriage bolts (from inside of chute) asshown
in FIGo 7A. flat washers, nuts and tighten..
_/ CHECKLIST
BEFORE
YOU OPERATE
AND ENJOY
YOUR NEW
SNOW THROWER,
WE WISH TO ASSURE
THAT YOU
RECEIVE
THE
BEST
PERFORMANCE
AND
SATISFACTION FROM THIS QUALITY PRODUCT.
PLEASE REVIEW THE FOLLOWING CHECKLIST:
#'
All assembly instructionshave been completed.
4'
The discharge chute rotates freely.
/
No remaining !oose parts in carton_.
WHILE
LEARNING
HOW
TO
USE
YOUR
SNOW
THROWER,
PAY
EXTRA
ATTENTION
TO
THE
FOLLOWING IMPORTANT ITEMS:
/./'
Engine oil is at proper level.
i'v" Make sure gas tank is filied properly with clean, fresh,
unleaded gasoline.
/,/'
Become familiar
with all controls-their
location and
function. Operate controts before starting engine.
LEVER
FIG. 6
T.A'c:noN
cLuTC. L E.
Au E" C LuTc, LEVER
CONTROL CABLES
FIG.7
LOCKNUTS
FLA'TWASHER
SNOW CHUTE
_,GE
BOLTS
FLANGE
FIG. 7A
9
Publicidad
