Tube Feed Heads; Assembly; Bulk Feed Head - Robot Coupe CL 60 Manual De Instruccion

IMPORTANT : This feed head cannot be used for
making french fries and can therefore not be
fitted with the corresponding attachments.
Two types of tools have been designed for the pusher-
feed head:
1) The long locking nut which holds the
plate for processing all vegetables
except for cabbage.
2) The hollowing nut, which is used
solely to prepare cabbage. Thanks to
this tool, you can slice or grate a whole
cabbage without first having to chop
it up.
A special tool has also been designed
to remove this hollowing nut.

• TUBE FEED HEADS

STRAIGHT TUBE FEED HEAD
This head consists of two
straight tubes with a diameter
of 3 inches, a 2 inches insert
and two pushers. The insert
allows you to modify the
diameter of the tubes.
This head is designed for the preparation of long
vegetables such as carrots, cucumbers, leeks, etc., or
fragile fruit and vegetables such as tomatoes and
bananas.
The tubes can also be used as cutting guides for
special preparations requiring high cutting precision
and a limited number of mis-cuts.
ANGLE FEED HEAD
This head performs the same
functions as the one described
above for the straight tubes.
However it is different in that it
is equipped with a biais cut
tube especially designed for
slanted cutting.
No special tool is required to attach the disc.

• BULK FEED HEAD

1) With the motor base
unit facing you, place the
discharge plate on the
motor shaft.
SIDE A facing upwards (ejection
rib downwards) for fragile vegetables
or citrus fruit (e.g. as tomatoes or
mushrooms).
SIDE B facing upwards (ejection rib
upwards) for all other types of fruit or
vegetables.
2) Position the plate or attachment you require :
plate should be resting on the motor shaft pin.
b) If you have chosen a dicing combination :
i.e. a grid and a special slicing plate.
Slicing plates and dicing grids can be mounted in
the following combinations :

ASSEMBLY

dicing
5x5
grid
Plate mm
5 mm
28110
8 mm
10 mm
14 mm
20 mm
25 mm
The shaded areas indicate combinations
that can be used.
sure the plastic tab on the outer rim of the grid is fully
seated in the corresponding slot in the motor unit.
a) If you have opted for
a slicing, grating or
julienne plate :
Position the plate on the
motor shaft.
Rotate the plate until it
drops into place onto the
motor shaft pin. The slot
in the center stem of the
8x8 10x10 14x14 20x20 25x25
mm mm mm mm mm
28111
28112
28113
28114
28115
Fit the dicing grid over
the motor shaft. As
shown in the picture, the
grid rests on a ledge in
the motor base.
This ledge must be clean
and free of product in
order for the machine to
operate correctly. Make
7