Whole Head "Pusher" Feed Head; Important - Robot Coupe CL 60 Manual De Instruccion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Then, fit the correspon-
ding slicing plate onto the
motor shaft. Rotate the
plate until the slot in the
blade hub drops onto the
pin in the motor shaft.
Continue to rotate the
blade a full 360 degrees
to make sure the plate
doesn't scrub against the plastic grid. If rubbing
occurs, do not proceed. Call your authorized servi-
ce agency.
c) If you want to use
the French fr y cutting
equipment : a grid and
a special slicing plate.
Position the French fry
grid over the motor shaft.
As shown in the picture,
the grid rests on a ledge
in the motor base. This
ledge must be clean and free of product in order for
the machine to operate correctly. Make sure the
plastic tab on the outer rim of the grid is fully
seated in the corresponding slot in the motor unit.
The cutting blades on the grid should be facing the
exit chute.
Next fit the appropriate
slicing plate onto the
motor shaft. Rotate the
plate until the slot in the
blade hub drops onto the
pin in the motor shaft.
Continue to rotate the
blade a full 360 degrees
to make sure the plate
doesn't scrub against the plastic grid. If rubbing
occurs, do not proceed. Call your authorized
service agency.
8
3) Screw the rubber agi-
tator onto the motor
shaft.
4) Position the bulk feed
head on the motor base.
The fastening hook
should now be facing
you, on your right.
5) Slide the hinge pin
into the spaces provided
at the back of the motor
base. Then, lock the lid
onto the motor base with
the fastening hook.
6) If you have a feed
tray, position it on the
top of the bulk feed
head.
7) Insert the crank into
the central hub of the
head. Turn it until the
part is inside the hub.

• WHOLE HEAD "PUSHER" FEED HEAD

To assemble the discharge plate, slicing, grating
or julienne disc or dicing equipment, follow the
procedure for the automatic head in steps 1) and 2).
IMPORTANT : This feed head cannot be used for
making french fries and can therefore not be
fitted with the corresponding attachments.
3) Then, screw the long locking nut or hollowing
nut onto the motor shaft according to the type of
vegetable being processed.
It should be remembered that the long locking nut
is suitable for all types of vegetables except for
cabbage, for which the hollowing nut has been
designed.
4) Position the pusher feed head on the motor base.
The fastening hook should now be facing you, on
your right.
Slide the hinge pin into
the holes provided at the
back of the motor base.
Then, lock the head onto
the motor base with the
fastening hook.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido