SAFETY INSTRUCTIONS. READ CAREFULLY
The following standard should be followed in the whole electrical installation: CEI 64-8
that refers to "the construction of electrical installations both in indoor and outdoor swimming pools", or
similar regulations in force in each area or country.
• "The entire filtering system follows the installation standard CEI 64-8 that stipulates that all electrical
apparatus located at less than 3.5 m. from the swimming pool and freely accessible should have a very low
voltage of 12 V. All 220 V apparatus should be positioned at least 3.5 m. from the edge of the swimming
pool. Apply to the manufacturer for permission to modify one or more elements of the filtering system".
• Filter medium type: synthetic based cartridge filter
• After using chemical products for treating pool water, it is recommended that a minimum filter time is
adhered to for the health protection of bathers, in accordance to health regulations.
• Electrical installations should only be performed by professional installers qualified in electrical installations.
• The apparatus should not be on while the swimming pool is being used.
• Do not operate the apparatus without water.
• People should NEVER touch the apparatus when it is on if they are wet or with wet hands.
• DISCONNECT the apparatus from the mains before handling.
• Ensure that the ground is dry before touching the electrical equipment.
• Never place the apparatus where it could become wet, as this could cause electrocution.
• Do not allow children or adults to lean against or sit on the apparatus.
• If the flexible power supply cable of the apparatus is damaged, it should be replaced. If in doubt, consult
your technical service.
• The transformer power cable cannot be replaced. If the cable is damaged, the transformer must be repla-
ced.
Filtering speed
Flow rate
Filtration area
Motor
Motor voltage
Transformer
Frequency
Protection rating
24
2,95 (m
/h) m
2
2
1,3 m
/h
3
0,44 m
2
60 W
12 V
230 / 12 V
50 Hz
IPX8