General Rules - Sandri Garden SG 925/30 CS Manual De Instrucciones

PETROL CHAIN SAW FOR TREE SERVICE USER MANUAL
STARTING A WARM ENGINE
1) Raise the switch lever "i" (Fig 31 part.1).
2) Pull the air knob as far as it will go and then
push it in to
ADVANCEMENT" - START.
3) Give the starter cord handle a strong pull until
the engine starts fig. 34.
STARTING WITH THE ENGINE HOT AFTER
REFUELLING
1) If the fuel tank has been emptied completely,
after refuelling follow the instructions given for
"STARTING WITH THE ENGINE COLD ".
STOPPING THE ENGINE. The engine must
ALWAYS be stopped in the following cases:
# When refuelling
# When oiling the chain
# When carrying out checks and repairs
# When cleaning and adjusting the chain saw
# When moving the chain saw in the working
area
# During transport
8. CHAIN SAW OPERATION
- When necessary, this
special type of chain saw
may be used with a single
hand by a trained operator who is using a
correct and safe working method to prune
trees and remove branches; all other op-
eration, on the other hand, must be carried
out 2 hands, as required with a traditional
chain saw (fig.11-A).
- Comply with all safety rules described in
chapter "SAFETY".
- Cut the tree by pushing the throttle lever
all the way and come into contact with the
wood after the engine has reached full
speed.
36
"THROTTLE
engage
8.1 USING THE CHAIN SAW ON TREES WITH
ROPES AND SLINGS
The following instructions are only
examples of how to use the chain
saw in the best possible way: however, all
current local and national laws must always
be complied with.

8.2 GENERAL RULES

- An operator who works on a high position on a
tree with the aid of ropes and slings must never
be on his own, but must be assisted on the
ground by a second, experienced operator, able
to handle emergencies.
- The operator must be trained to safely climb
trees, to use a working technique suitable for jobs
carried out at heights and must be equipped with
suitable safety sling, ropes and snap-shackles,
and any other items required to ensure a stable
and safe working position for himself and the
chain saw.
8.3 PRELIMINATY OPERATIONS WHEN US-
ING THE CHAIN SAW ON A TREE
1) The chain saw must be checked, refuelled,
oiled, started and heated by the second opera-
tor on the ground, then the engine must be
switched off before lifting the chain saw on the
tree.
2) The chain saw must be fixed with a snap-
shackle to the operator's sling by means of a
rope (fig.13).
3) The chain saw must be anchored to the con-
nection point (fig.12 item1) by means of a rope.
4) The sling rope extends beyond the snap-
shackle all the way to the lifting rope on the
ground.
5) Make sure that the chain saw is fixed to the
sling before detaching it from the lifting rope.