Mosa GE 6000 SX/GS Manual Del Usuario página 51

© MOSA 1.0-11/99
When the TCM 5 5D-6 is used, it is not possible to connect the E.A.S automatic intervention unit.
USE OF THE REMOTE CONTROL TCM 5
The coupling of the TCM 5 with the generating set,
permits to work far from the set itself.
The remote control is connected to the front plate,
with a multiple connector.
The TCM 5 assures the following fonctions:
- starting (starting key Q1)
- stop (starting key Q1)
- choke control (L6)
1) the position of the selector LOCAL START/RE-
MOTE START (l6) on the generating sets GE
4500 HSX and GE 4500 SX-EAS must be on
the position "REMOTE START".
2) The position of the key (Q1) on the generating
set GE 4500 SX-EAS must be on the position
"ON"
USE OF THE REMOTE CONTROL TCM 5D
The coupling of the TCM 5D with the generating
set, ready for remot starting, permits to work far
from the set itself.
The remote control is connected to the front plate,
and/or rear plate, with a multiple connector.
The TCM 5D assures the following fonctions:
- starting (starting key Q1)
- acceleration (selector 16)
- stop (starting key Q1)
- indication of oil low pressure (warning light O1)
To stop the set, move the accelerator lever (16) to
the minimum position, them turn the key to "OFF"
position.
USE OF THE REMOTE CONTROL TCM 6
The coupling of the TCM 5D with the generating
set, ready for remot starting, permits to work far
from the set itself.
The remote control is connected to the front plate,
and/or rear plate, with a multiple connector.
The TCM 5D assures the following fonctions:
- starting (starting key Q1)
- stop (starting key Q1)
- indication of oil low pressure (warning light O1)
To stop the set turn the key to the position."OFF".
O1)
Per l'arresto del motore portare la chiave sulla posi-
zione "OFF".
ACCESSORY USE
!
MAKE SURE
MAX
MIN
16 O1
O1
REMOTE CONTROL
TCM 5 - 5D - 6
SCREW TIGHT
OFF
ON
START
SCREW TIGHT
Q1
OFF
ON
START
SCREW TIGHT
Q1
M
38.5
PUSH AND
TCM 5D TCM 5D
OFF
PUSH AND
TCM 6 TCM 6
OFF
PUSH AND