Publicidad
Idiomas disponibles
Idiomas disponibles
,.-1
CHARGINGTHE
BATTERY PACK (Fig° 4 and 4a)
All Models
The battery
pack lot this tool has been shipped in a low charge condilion
to prevent
possible problems.
Therefore,
you should
charge overnight
prior to use..
I NOTE: Batteries
wtll not reach full charge the first ttme they are charged.
Allow several
cycles (operation
followed by recharging}
for them to become
fully charged.
1 Charge battery pack onfy with the charging
stand f transformer that was supplied wilh
this drill / driver.
2 Make sure power suppty is normal
household
voltage. 120 volls, 60 Hz.
AC,onty,
3 Connect
charging
stand's transformer
Io
power supply.
4 Place battery pack in charging stand., Align
raised rib on battery
pack with groove In
charging
stand (See Fig 4).
5, Press down on battery
pack to be sure
contacls
on battery
pack engage
properly
with contacts in charging stand,
6The
charging stand
has two (LED) indicator
lights, one green and one red
When a battery
pack ls put into the charging
stand, the red LED wtll light,
indicating that the battery pack is charging
properly
(see Fig 4a),
When the battery pack is charged and
removed
Irom the charging stand, the red
light will go Off The green LED will come on
only when there is a problem
with the
battery or charger,,
7 After normal use, 3 hours or less of charging
time ts required to fu]ty recharge
battery
Fig. 4
Transformer
pack
II battery pack iscompletely
discharged,
6 hours or longer of charging
time is
required to fully recharge
battery
pack,
I
OTE: Within the warranty
period, tf the charglng
stand LED lights
do not
operate
properly,
or the charging
stand does not charge the battery
pack, return
the charging
stand / transformer
and battery pack to your nearest
Sears Store or
other Craftsman
outlet for free replacement°
15
7-11-07
Publicidad
