Publicidad
Idiomas disponibles
Idiomas disponibles
..... l
Ak CAUTION:
When placing
battery pack in the tool, be sure raised
rib on
battery pack aligns with the bottom
of the drill and latches
Into place properly.
Improper
Installation
of the battery pack can cause damage
to internal
components.
WARNING:
Cordless
Battery Tools are always
in operating
condition
when
the battery pack Is installed
in the tool.Therefore
the Forward
/ Reverse
Selector
Switch with Power Lock.Off
should
always
be in the center position, locking
the
power off, when the tool is not In use or when you are carrying
it at your side.
TRIGGER SWITCH (Fig. 6, 6a and 6b)
To turn the drill ON, push the Forward/Reverse So{actor Switch with Power Lock-Off to lhe
FORWARD or REVERSE location (sea arrow direction embossed on swilch), and depress
the triggerswitch.To turn the drt!lOFF, release the trigger swttch_
FORWARD
REVERSE
VARIABLE SPEED (Fig. 6b)
The variablespeed triggerswitchdelivershigher speed and torque with increased
pressureon the triggerswitch end lower speed and torque with decreased pressure on
the triggerswitch,
1
NOTE:You
might
hear a whistling
or ringing
noise
from the trigger switch
when
|
operating
at low speeds° Do not be concerned;
this ts e normal
part of the
/
switch functiorto
ELECTRIC
BRAKE
To slop the drill/driver,
release the trigger switch and lhe eiectric brake will stop the chuck
instantly,,
NOTE: The drill/driver
will not operate
unless the Forward
/ Reverse
Selector
Switch with Power Lock"off
is pushed fully
to the left (forward)
or to the rtght
(reverse).
Avoid running the drill/driver
at low speeds for extended periods of time, Running al low
speeds under constant
usage may cause the drt!_drtver to become overheated., ff this
occurs, cool ihe drill/driver
by running it without a Iced and at futi speed.
17
7-11-07
Publicidad
