Installation Of The Indoor Unit - mundoclima MVD DC2 Manual De Instalación Y Usuario

Steel framework
Directly set and use an angled steel rod for support.
Suspension bolt
Suspension bolt
Figure 3.3
Newly set concrete slab structure
Set using embedded appliances, and embedded type of bolts.
Knife-type
insertion piece
embedded bolt for piping)
Figure 3.4
Angled rod
for support
Sliding-type
insertion piece
Reinforced bar
Embedded bolt
(hanging and
Caution
‡ $OO EROWV VKRXOG EH PDGH IURP KLJK TXDOLW\ FDUERQ VWHHO ZLWK
galvanized surface or other rust prevention treatment) or
stainless steel.
‡ +RZ WKH FHLOLQJ VKRXOG EH KDQGOHG ZLOO GLIIHU ZLWK WKH W\SH RI
building. For specific measures, please consult the building
and renovation engineers.
‡ +RZ WKH OLIWLQJ EROW LV VHFXUHG GHSHQGV RQ WKH VSHFLILF
situation, and it must be secure and reliable.

3.2 Installation of the Indoor Unit

(1) When mounting the lifting lugs of the indoor unit on the lifting bolts,
slot the nut washers of the lifting bolts in the oblong holes of the
lifting lugs. The upper and lower nuts and the washers are shown
in Figure 3.5.
(2) Adjust the height of the indoor unit.
(3) Use a spirit level to verify that the unit body is level (making the
unit body slope downwards towards the drainage side), as shown
in Figure 3.6.
Lifting bolt
Nut (bottom)
Washer (bottom)
Nut (bottom)
Ceiling
Make sure the connections are tight.
27
Nut (top)
Installation of
lifting lugs
Figure 3.5
Spirit Level
Figure 3.6